There are a lot of things to pay attention to when using the fume purification product supplier, because there is a large amount of slowly falling powder in the ash hopper of the fume purification product supplier, and the upward air leakage airflow forms the secondary flying of the falling dust, which is more than the dust concentration of the intake air, thus worsening the working conditions of the dust removal equipment and affecting the dust removal power of the bag filter.

During the application of fume purification product supplier, it is necessary to prevent the gas from cooling below the dew point in the bag chamber, especially when using the dust collector under negative pressure. Because the dust concentration of the dust source gas is high, even if only 1% short circuit escapes, it will exceed the emission standard. Because air often leaks into the shell of the fume purification product supplier, which makes the gas temperature in the bag chamber lower than the dew point, the filter bag will be affected with moisture, causing the dust not to be loose, but to adhere to the filter bag, blocking the fabric holes, forming a dust removal failure, making the dust removal system too pressure drop, unable to continue operation, and sometimes the paste bag can not remove dust.

Block the air leakage of fume purification product supplier, especially at the ash discharge port of electrostatic precipitator. The dusty gas escapes directly from some gaps without passing through the filter bag, which is not allowed to happen. Therefore, care should be taken in planning, installation and inspection. Most of the rotating air flow of the fume purification product supplier moves from the cylinder to the bottom of the cone in a spiral form along the wall, forming a falling external dust laden air flow. The centrifugal force generated in the process of strong rotation throws the dust particles whose density is far greater than the gas towards the wall. Once the dust particles contact the wall, they lose their inertial force and fall into the ash hopper along the wall with the momentum of the inlet speed and their own gravity.

After reaching the bottom of the cone, the swirling downward airflow of the fume purification product supplier turns upward along the axis of the dust remover to form an upward internal swirling airflow, which is discharged from the exhaust pipe of the dust remover. Another small part of the air flow from the air inlet of the fume purification product supplier flows to the top cover of the cyclone dust remover, and then flows downward along the outer side of the exhaust pipe. When it reaches the lower end of the exhaust pipe, that is, the reverse direction upward is discharged from the exhaust pipe along with the rising central air flow, and the dust particles dispersed in it are also carried along with it.

fume purification product supplier https://www.kaisenfilter.com/About.html